"لنش بحري للوكيل السياسي في البحرين. مراسلات تتعلق بمحرك كيلفين." [ظ‎و‎‎١] (٣٩٨/١٤)

646
Kelvin-Diesel Engine and Marine Equipment
Model K3 with 3 Cylinders, 66 Horse Power
The engine is illustrated opposite and is complete with reversing gear, clutch, starting
gear, governor, fuel pumps, filter, crankcase pump, water pump, silencer, flywheel and pan,
etc. The standard equipment is as follows and, with the addition of woodwork, is suitable to
complete an installation in a normal boat without further outlay.
SHAFTING (see page 652).— Steel intermediate shaft 2£ inches dia., bronze propeller shaft
2i inches dia.. 2 shaft bearings, 2 shaft couplings, bronze propeller with 3 blades, brass stern-
tube with nut and brass stuffing box. (The lengths are given below, sterntube is measured
between flange and nut, steel and bronze shafts overall, bracket from centre of shaft to
planking, sterntube is 2 T ^ outside, hole through sternpost should be 2f, stuffing box flange
5|x4i). 0
EXHAUST CONNECTIONS—Elbow at silencer, exhaust pipe 8 feet long with flange
one end, 2 bolts, 2 joints, exhaust hull flange (or elbow if ordered, see page 652), with brass
bolts.
WATER CONNECTIONS.—1-inch bore. G.M. seacock with Monel Metal strainer ; G.M.
elbow ; copper water pipe 2 feet long with flange each end ; 4 brass bolts and 4 joints.
FUEL EQUIPMENT (see tank sheet) .—One Vertical Pressure Feed Tank 3 feet dia.; 140
gallons, with fittings and bolts, tank gauge and pipes; air pump on engine; one fuel pipe
f-inch X 16 feet; one air pipe J-inch x 16 feet; 2 couplings |-inch and 2 couplings 5 -inch.
TOOL BOX as page 653, 4 brass foundation bolts; 8 levelling washers; 2 stay bars 6 feet
long, 4 bolts and 6 coach screws X 6".
66 Horse Power at 750 r.p.m. on 3-06 gallons per hour. Propeller 29 inches.
Equal to 405 pounds or -37 pints per brake horse power per hour. Guarantee Page 640.
F or C bntiial I nstallations.
F ok S ide I nstallations.
With shaft angle of 10°
With shaft angle of 20°
1 Engine and Equipment as enumerated
above, Shafting, etc., as shewn on
the right.
Steel shaft 16 ft.
Bronze shaft 5J ft.
Stemtube 2i ft.
Steel shaft 16 ft.
Bronze shaft 8 ft.
Stemtube 5 ft.
Steel shaft 16 ft.
Bronze shaft 13 ft.
Stemtube 42 in.
Staytube 63 in.
Bracket 14i in.
Steel shaft 16 ft.
Bronze shaft 8 ft.
Sterntube 19 in.
Staytube 29 in.
Bracket 12i in.
Prices at works, packing for
export 3% extra, free in the
United Kingdom if cases are
returned carriage paid.
VALAL
VAMAM
VANAN
VAPAP
IMPORTANT.— The exhaust must discharge above sea level, and the silencer must be slightly above the point of discharge.
To fulfil these conditions, order a standpipe of the height necessary.
Add to Code
ATUNO
ATDUO
ATRIO
CERTE
STEEL
REFOL
FOLCH
Silencer mounted on standpipe 8^ inches high, -----
17 .... -
» 25i „ . . . . .
Power and consumption certified by Lloyd's - - - - -
Steel shaft, two bearings and one shaft couphng omitted, _ - -
With reversible folding propeller instead of solid propeller, -
With non-reversible folding propeller and clutch (no reverse),
Box of spare parts (recommended for Engines shipped abroad), -
Electric light dynamo mounted on engine, and switch board, 130 watts
Electric light dynamo mounted on engine, and switch board, 300 watts
Bilge and wash pump -
Add
Deduct
Add
Add
Add
Add
Add
Add
£ 3 0
£8 0
^14 0
£ 2 10
£
£17 10
^35 10
^12 0
dynmo A
OMNYD W
BILGE
Nett weight of " VALAL " 4527 pounds. Packed weight Pounds, measurement
Nett weight of the engine only as illustrated - - 3622 Pounds.
cubic feet.
t
V